Full screen Standard. Page of 32 Go. Do not attempt to operate this oven with the. It is important not to defeat or tamper with the safety interlocks. Under normal conditions, the oven will not operate with the door open. Do not place any object. Your microwave oven is a cooking device and you should use as much care as you use with a stove or any other. When using this electric appliance, basic safety precautions should be followed, including the following: WARNING ———To reduce the risk of burns, electric.
Read all instructions before using the appliance. This appliance must be grounded. Connect only to a. Install or locate this appliance only in accordance with. Do not cover or block any openings on this appliance. Do not store or use this appliance outdoors. Do not use. Use this appliance only for its intended use as. Do not use corrosive. This type of. When cleaning surfaces of door and oven that come. As with any appliance, close supervision is. Do not operate this appliance if it has a damaged.
To remove this connector, pull the lead wire by pressing an extruded lever in the center of receptacle terminal as shown. Replacement of upper antenna 1. Remove ceiling plate by gently moving the left and right tabs inward while pulling the plate down and outward. Using a small flat screwdriver or the like, remove two plastic clips located on the antenna ring. Remove 2 screws holding temp sensor and replace with new one.
Solder the lead wires securely to the sensor terminals. Disassembly of door assembly 1. Remove each 2 bolts holding upper and lower hinges. High voltage transformer 1. Remove connections from the transformer terminals and check continuity.
Normal cold resistance readings should be as follows: Secondary winding Approx. Temp sensor Thermal protector A temp sensor is mounted on exhaust guide. Its purpose is to automatically shut off the oven in case the cavity overheats for any reason. Place the beaker on the center of ceramic shelf. Set the one to High power and heat it for exactly one minute. Record keeping and notification after measurement 1. After any adjustment or repair to a microwave oven, a leakage reading must be taken. Important safety notice: Components identified by mark have special characteristics important for safety.
When replacing any of these components, use only manufacture's specified parts. Part No. Page Ref. Print page 1 Print document 48 pages. Rename the bookmark.
Delete bookmark? Cancel Delete.
0コメント