Rv cover installation

Pull the front of the RV Cover over your camper, methodically working it towards the front while ensuring it does not snag on corners, ladders, racks, etc. Drape the side panels down over the RV. Climb down the ladder and adjust the RV cover into place using the corners as guide points. Pulling the elastic corners beneath the coach should begin to hold the RV cover in place. Use the weighted strap and buckle mechanisms to secure the cover underneath the RV.

Do not over tighten the buckle mechanism; you do not want to apply potentially damaging pressure; the goal here is merely preventing the wind from removing your RV cover. Locate the eye-holes on each corner of the RV cover. Use a piece of rope or twine to connect both front corners together, and then use another piece to connect both back corners. Only then should you secure the bottom corners. Once they are in place. Adjust the straps and buckles located at each end of the RV Cover. Doing so will secure any excess fabric and prevent shifting in light wind.

STEP 9: Finally, secure the bottom and middle straps and buckles. Use the weighted buckle bag to help toss the straps beneath Your RV. STEP There you have it; your cover fits perfectly and you did a great job. Installation and removal are safer and easier when done by two people. How to Clean your cover The RV cover can only be washed by hand.

Warnings Do NOT use soap. Do NOT use bleach. Do NOT use fabric softener. Do NOT iron. Do NOT store the cover if wet. Air-dry the cover. Frequently Asked Questions How to know what is the front of the cover? What are all those vertical zippers around the cover? What are the built in straps with velcro in the inside of the cover? How to install the ladder cap protection cover? How to install the rain gutter protection cover? Remove the antenna if possible. Step 3: Pull the front of the cover up with you as you climb up the ladder..

Once on top of the RV, pull as much as you can towards the top, creating a pile of cover next to your feet. Once the pile gets big enough, stretch it towards the front of the RV.

Step 4: Once a strip of cover is created, start at the front by pacing the cover over the corners, working your way towards the back, allowing the cover to drape over the sides of the RV. Step 5: Once you are at the rear of the RV, place the cover over the corner opposite of the ladder.

Climb down the ladder pulling the cover down with you. Put ladder cap if needed in place prior to covering the rear bumper.